Clip-in Security Ceilings

Typical K40 Specification

General description: Polyester painted unperforated steel tiles supported in a concealed clip-in grid system.

Membrane material: Zintec steel tiles.

Size: On application.

Thickness: 0.6mm minimum, with electroplated zinc finish to BS EN 10143:1993.

Edge detail: On application.

Finish: Electrostatically applied polyester paint. High opacity formulation to an optimum thickness of 45 microns.

Colour: Standard White colours either BS 00E55 12% gloss or RAL 9010 20% gloss. Other BS or RAL colours available on request. Specified colour to be controlled to Delta E tolerance of 0.5.

Suspension system: Burgess H4 concealed grid system comprising primary grid section ref: GT112 suspended from the soffit at 1200mm maximum centres by galvanised mild steel angle hangers ref: GT114.

Hangers to be secured to primary grid using M6 or equivalent fixings. 45mm wide x 29mm deep x 0.8mm thick galvanised mild steel Spring Tee bars, ref: GT115, to be connected to the primary grid using Universal Bracket, ref: GT109, at centres corresponding to tile length. Tiles are to be pre-drilled to take security clips ref. GT1071, 1 clip to be used per tile.

Perimeter Trim: Galvanised mild steel perimeter trim, ref: GT119, colour and finish to match tile.

Fire Performance: The ceiling system must be fully tested in accordance with BS 476 Parts 6 and 7 and be of such performance as to be designated CLASS 'O' under United Kingdom Building Regulations. The ceiling system must be fully tested in accordance with BS 476 Part 8 and be capable of providing 1 hour fire protection to steel beams. Recommended Manufacturer. Burgess Architectural Products Limited, Leics., England.

We only recommend the use of Burgess Tee Bar for this system. Each piece of Burgess Tee Bar is identified as such on the rear face.